![used wolverine 8mm film to digital converter used wolverine 8mm film to digital converter](https://www.kodak.com/content/products-images/Consumer/_1200x630_crop_center-center_82_none/Kodak-Scanza-Digital-Film-Scanner-2-v2.jpg)
- Used wolverine 8mm film to digital converter 720p#
- Used wolverine 8mm film to digital converter mp4#
- Used wolverine 8mm film to digital converter pro#
The 20fps capture of the pro model is better than the 30fps of the predecessor but it's still not quite the usual 16fps & 18fps playback rate.
Used wolverine 8mm film to digital converter mp4#
Then you need to reverse the recorded MP4 in your computer's video editor. Another suggestion is to run your reel through the scanner backwards so the claw it grabbing the less used side of the sprocket holes. The folded paper trick has also been helpful. Read their online FAQ for some other tips & trips. I've done a few reels successfully this way. Splice tapes may help with sprocket hole damage. Thick splices and warped film can also cause problems. If you have worn sprocket holes, or badly damaged ones, the wolverine pro will hang up. The single claw is the only thing advancing the film past the scanner. If you are using a CRT monitor, use one with an underscan option so you can see the entire frame. For more accurate frame adjustment, you should connect your Wolverine to a larger display monitor that accepts a composite input. I think this is fine for general menu navigation, but I don't like it for doing frame adjustments.
![used wolverine 8mm film to digital converter used wolverine 8mm film to digital converter](https://petapixel.com/assets/uploads/2021/11/71WS6qNjdL._AC_SL1500_-800x756.jpg)
The Wolverine has a small LCD screen built-in. It will really bog down with larger reels. I recommend rewinding your reels by hand. Bypassing a spindle on the take-up side might help with this. A similar problem can happen on the take up side as a large reel fills up, it sometimes gets too heavy and the take-up reel may cease its duties and you get a mess on the other end. If left unattended, you may come back to quite a mess. The source reel on the wolverine has very little friction and spins quite freely, too freely sometimes. Another problem I've experienced with larger reels is the unraveling reels. Dust and dirt will accumulate more with longer reels too. As you work with larger reels, there's greater chance of something going wrong and wasting a lot more time. A 3" reel takes about 30min to process, a 5" takes about 2hours. And then a good blasting of compressed air on the Wolverine after each pass.Īlthough the pro model can accommodate up to 9" reels, I don't recommend using anything larger than 5". I recommend inspecting, cleaning and repairing the film reels before scanning. So I do a 4:3 size zoom and a zoomed out pass with sprocket holes that can be cropped later into a 16:9 framing. I may do 2 passes on some reels because a greater area of film was exposed. It has done a fairly decent job when things are working smoothly.
Used wolverine 8mm film to digital converter 720p#
It offered some improvements over the original model such as increased resolution from 720p to 1080p, larger reel accommodation, and 20fps capture rather than 30fps. I decided to give the Wolverine Moviemaker-Pro a try. I have a lot of family home movies on 8mm & Super8. Topic: Wolverine Moviemaker-Pro thoughts and issues Wolverine Moviemaker-Pro thoughts and issues My profile | my password | search | faq | register | forum home 8mm Forum: Wolverine Moviemaker-Pro thoughts and issues